Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.Interference to radio or television reception, which can be determined by turning the equipment offĪnd on, the user is encouraged to try to correct the interference by one or more of the following Interference will not occur in a particular installation. Radiate radio frequency energy and, if not installed and used in accordance with the ni structions, mayĬause harmful interference to radio communications. These limits are designed to provide reasonable protectionĪgainst harmful interference in a residential installation. ![]() This equipment has been tested and found to comply with the limits for a Class B digital device, Power source: AA 1.5 V, 4 alkaline batteries are used. There is danger of explosion if the battery is inserted reversely. ![]() When the operation of the safe box is disabled until the set time and displays the timeģ) Unlock with Master Card during the safe box disabled.ĭisabled Time Count down, e.g. Then confirmation melody of saved password sounds and displays ‘CLOS”Ģ) Lock the safe box by entering password only, without pressing "RESET".ģ) More than 5 seconds entry time lapse cancels the password input.Ĥ) Pressing “RESET” during password entry cancels the input and have to retry.ĥ) Warning signal sounds and “Err2” display on the 7 Segment if the safe box is not lockedġ) Enter password and unlocked confirmation sounds and displays ‘OPEN” on theĢ) Unlock the safe box by entering password only, without pressing "RESET".ĥ) Warning signal sounds and “Err2” display on the 7 Segment if the safe box is notĢ) The safe box is locked with the same password previously entered by pressing ‘”RELOCK”ģ) Warning sounds and display “Err2” on the 7 segment if not locked successfully.Ģ) After 5 times wrong password entries, “Err1” displays and warning sounds, Vender ID corresponds to hotel ID and Customer ID corresponds to Room number.ġ) Enter password and press “LOCK”, when 7 Segment blinks 3 times. * set RELOCK lapse time by the minute and as default , Lock the safe box by pressing “Relock” with same password previously entered Operation disabled by the minutes after 5 times wrong password entry (default 15 Password display is optional when unlocking (no display as default) Password display is optional when locking (display as default) Safe box operates in the Free Mode, half-cycle mode. Warning sound beeps and “SEr” displays on the 7 segment when trying to use safe Necessary operational functions are set in the Setup Card. “Err2” displays when the operation or hardware function fails. ‘SEr” displays when the operational functions are missing and system is in the failure Set necessary operational functions on the Setup Card before operating Safe box. Initial password is set as "1234" and new password is set with 4 digit. Systems cards for Safe box operation consist of Key Card, System Card, Guest CardĪnd starts with pressing "RESET" button on the safe box. Time set by Setup settings after unlocking. Previously entered password is valid within the default set Press "LOCK" button and safe box is locked. ![]() Place guest Card on the ‘LOCK’ of the Safe box. The operation is on the halt for 30 minutes after Press ‘RESET” button to cancel entering password. Safebox is unlocked entering 4 digit password Place Guest Card on the “LOCK” of the safe box. Press “RESET” to cancel entering password. Safe box is unlocked entering password "1234" andĮnter 4 digit password and press “LOCK” button.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |